Horizontal Rainwater Outlet Download PDF

A how-to guide to installing a horizontal rainwater outlet.

Step 1

Place the outlet through the wall and mark around it using a crayon or similar, allowing an additional 1cm around the perimeter.

Step 2

Stir thoroughly and prime the underside of the outlet and the marked area on the rubber using a quick scrubber pad and handle. Allow both surfaces to dry.

Step 3

Mate the outlet to the rubber and seal in place using a penny and silicone roller.

Step 4

Round the corners of the 18" SA flashing (outlet kit) with scissors and neatly position over outlet. Mark the perimeter with crayon.

Step 5

Prime the rubber and outlet using the quick scrubber pad and handle and extend primer beyond the crayon line by 2cm and into the mouth of the outlet by 100mm.

Step 6

Once touch dry, working from the bottom, position the 18" SA flashing and carefully remove the backing paper. Ensure it is tightly sealed into the corners and use a penny and silicone roller. Carefully cut the sides and top at the aperture and allow flap to drop into the primed outlet.